PREMOTAG provides a reliable and high performance solution in HF band radio frequency identification field (13,56MHz) specially designed to work on metal surfaces and environments where high resistance is needed.
6/11/2009
HF TAGS for metal surfaces application
PREMOTAG provides a reliable and high performance solution in HF band radio frequency identification field (13,56MHz) specially designed to work on metal surfaces and environments where high resistance is needed.
A RFID standard inlay (label with air core coil) does not work fine when it is attached to a metallic surface due to Eddy current. The effect is that very high losses shortcut the magnetic field; making the inlay useless to control or tracking this kind of devices. Premotag solves this problem by using an inside antenna (ferrite core) which makes all magnetic field lines pass through it and avoiding negative effects. Therefore the PREMOTAG has a good performance even on metallic surfaces.
The tag provides a plastic enclosure PA66 (UL94 V-0, flame-resistant) completely sealed by polyurethane resin which gives the device a protection degree of IP68 suitable fot outdoor and industrial environment.
Its small size (33.3 x 14.6 x 9 mm), lower than standard RFID labels in the market, is achieved due to its special ferrite material with 13.56 MHz frequency operation. The ferrite antenna is connected to I-code NXP chip of 1Kbit memory (reader/writer) and ISO15693 protocol with anticollision. Others chips available under demand.
The PREMOTAG is available in two versions depending on assembly method:
Reading distances on non-metallic surfaces are 20cm and 11-15cm over metal surfaces (1W power); for higher powers (4W) the PREMOTAG reaches 50cm on non-metallic surfaces and the 25-30cm reading distances on metal surfaces, depending also of transmitting antenna size.
For more information about dimensions, electrical diagrams and values chart, please visit our website: http://www.grupopremo.com
Premo Group is a worldwide leading company designing, manufacturing and supplying standard or custom made inductive components for the electronics market. Our wide range of products as RFID transponder coils, EMC filters, PLC accessories, planar transformers, current transducers and chokes cover most applications in the different market sectors.
For further information you can always contact:
Communication Department:
Rocío Arrupe
Rocio.arrupe@grupopremo.com
PREMO Headquarter
Premo C/. Conchita Supervía
13 - 08028 Barcelona (Spain)
www.grupopremo.com
info@grupopremo.com
Phone number: 34 934 098 980
Fax: +34 934 906 682
Identification Systems: Radio Frequency
Vehicle Identification Systems: RFID
Tags: RFID
RFID Tags
Sensors: RFID
RFID Sensors